All 8 Switches can be programmed to engage any combination of the 8 loops (up to 8 pedals can be engaged at once). 60 presets - Allowing you to save 60 combinations of pedals.
Plug your chosen effect pedals into the SEND and RECEIVE sockets, then engage or disengage them using the footswitches. When one of the loops is'off', your guitar sound is routed directly to your amp. When it is'on', your signal is routed through the effects pedals. Switch 1 could be programmed to activate Loops 1, 3 & 4.
Switch 2 could be programmed to activate Loops 2,3,5, & 8. Switch 3 could be programmed to activate Loops 8. Switch 4 could be programmed to activate Loops 1,2,3,4,5,6,7 & 8. Hold down the footswitch that you would like to program for 2-3 seconds and release.Press the Loops that you would like to be activated by the switch you're programming (The LEDs will indicate the pedals that you've selected). Re-hold the initial footswitch for 3 seconds to finish. This can be repeated for the 7 remaining footswitches. Each switch can either be set to Programmable or On/Off mode. In programmable mode, the previously active switches disengage when a new switch is pressed.
In On/Off mode, the previously active switches stay on when a new switch is pressed, allowing you to add to existing effects. To toggle between Programmable and On/Off mode, hold your chosen switch down for 5+ seconds. The switch will flash fast for 3 seconds. You can mix and match between Programmable and On/Off modes. So for example: you could have 3 switches set to Programmable and 5 switches set to On/Off mode.
Standard-Preset mode vs Multi-Preset mode. In Standard-Preset mode all 8 switches act as a preset, so pressing any of the switches will engage a preset.In Multi-Preset mode, 2 of the switches (the right 2 switches) act as bank change switches to allow you to change banks of presets - the remaining 6 switches are for selecting the presets - there are 10 banks of 6 presets, so 60 presets in total. To toggle between Standard-Preset mode and Multi-Preset mode, hold switches 3 and 4 whilst inserting the power. Re-press the active switch to bypass all loops (In programmable mode).
Add True Bypass to any effects pedal. All 8 pedals can be engaged at once.
Program any of the switches to activate any of the loops. The loops engage immediately when a switch is pressed. Silent Switches (with Smooth clickless action). The item "Programmable 8 Looper Loop Pedal True Bypass Guitar Effects 60 Presets" is in sale since Thursday, September 18, 2014. This item is in the category "Musical Instruments\Guitars & Basses\Parts & Accessories\Effects Pedals\Loopers & Samplers".
The seller is "buzz_electronics" and is located in Dunmow. This item can be shipped worldwide.